448
SERVICING AND MAINTENANCE
2. Rotate the bulb socket a quarter turn and
pull it from the lamp assembly.
Removing Bulb Socket From Clearance Lamp
3. Pull the bulb straight from it's socket and
replace.
Rear Lamp Bar ID Marker (Dual Rear Wheels)
— If Equipped
See below steps to replace:
1. Loosen the two screws and the housing to
gain access to the bulb sockets.
Screw Locations
2. Turn the socket a quarter turn counter
-
clockwise to access the bulb.
3. Pull the bulb straight out from the socket.
4. Reverse the procedure for installation of the
bulbs and housing.
Side Marker Lamps (Dual Rear Wheels) — If
Equipped
See below steps to replace:
Side Marker Lamp Locations
1. Push rearward on the side marker lamp
assembly.
2. Pull the entire assembly from the fender.
3. Turn the socket a quarter turn counter
-
clockwise and remove from assembly to
access the bulb.
4. Pull the bulb straight out from socket.
5. Reverse the procedure for installation of the
bulbs and housing.
21_DJD2_OM_EN_USC_t.book Page 448