IN CASE OF EMERGENCY
383
R
EINSTALLING
T
HE
J
ACK
A
ND
T
OOLS
1. Tighten the jack all the way down by
turning the jack turn-screw counter
-
clockwise until the jack is snug.
2. Position the jack and tools into bracket
assembly. Make sure the lug wrench is
under the jack near the jack turn-screw.
Snap tools into bracket assembly clips.
Install the jack into bracket assembly and
turn the jack turn-screw clockwise until jack
is snug into bracket assembly.
Jack And Tools Bracket Assembly
3. Place the jack and tool bracket assembly in
the storage position holding the jack by the
jack turn-screw, slip the jack and tools
under the seat so that the bottom slot
engages into the fastener on the floor.
Jack Hold Down Fastener
NOTE:
Ensure that the jack and tool bracket assembly
slides into the front hold down location.
4. Turn the wing bolt clockwise to secure to the
floor pan. Reinstall the plastic cover.
Wing Bolt/Jack And Tools
H
UB
C
APS
/W
HEEL
C
OVERS
— I
F
E
QUIPPED
The hub caps must be removed before raising
the vehicle off the ground.
CAUTION!
Use extreme caution when removing the front
and rear wheel covers. Damage can occur to
the center cap and/or the wheel if screw
-
driver type tools are used. A pulling motion,
not a pry off motion, is recommended to
remove the caps.
7
21_DJD2_OM_EN_USC_t.book Page 383