RAM 2015 1500, Operating Information Manual, Page: 410 / 998

3. Place the jack and tool bracket assembly in
the storage position holding the jack by the
jack turn-screw, slip the jack and tools under
the seat so that the bottom slot engages into
the fastener on the floor.
NOTE:
Ensure that the jack and tool bracket assem-
bly slides into the front hold down location.
4. Turn the wing bolt clockwise to secure to the
floor pan. Reinstall the plastic cover.
Hub Caps/Wheel Covers — If Equipped
The hub caps must be removed before raising
the vehicle off the ground.
CAUTION!
Use extreme caution when removing the
front and rear center caps. Damage can
occur to the center cap and/or the wheel if
screwdriver type tools are used. A pulling
motion, not a pry off motion, is recom-
mended to remove the caps.
For single rear wheel (SRW) models, use the
flat blade on the end of the lug wrench to pull the
hub cap off. Insert the blade end into the pull off
notch and carefully pull the hub cap off with a
back and forth motion.
On 3500 models with dual rear wheels (DRW),
you must first remove the hub caps. The jack
handle driver has a hook at one end that will fit
in the pull off notch of the rear hub caps.
Position the hook and pull straight out on the
ratchet firmly. The hub cap should pop off. The
wheel skins can now be removed. For the front
hub cap, use the flat blade on the end of the lug
wrench to pull the caps off. The wheel skin can
now be removed.
CAUTION!
•
Use a pulling motion to remove the hub
cap. Do not use a twisting motion when
removing the hub cap, damage to the hub
cap; finish may occur.
(Continued)
Jack Hold Down Fastener
Wing Bolt/Jack And Tools (2500/3500 Series)
407