RAM 2015 1500, Operating Information Manual, Page: 376 / 998

WARNING!
Attaching a snowplow to this vehicle could
adversely affect performance of the airbag
system in a collision. Do not expect that the
airbag will perform as described earlier in
this manual.
CAUTION!
The “Lamp Out” indicator could illuminate if
exterior lamps are not properly installed.
Before Plowing
•
Check the hydraulic system for leaks and
proper fluid level.
•
Check the mounting bolts and nuts for proper
tightness.
•
Check the runners and cutting edge for ex-
cessive wear. The cutting edge should be ¼
to ½ in (6 cm to 1.2 cm) above ground in
snow plowing position.
•
Check that snowplow lighting is connected
and functioning properly.
Snowplow Prep Package Model Availability
For Information about snowplow applica-
tions visit www.ramtrucks.com or refer to
the current Body Builders Guide.
1. The maximum number of occupants in the
truck should not exceed two.
2. The total GVWR or the Front GAWR or the
Rear GAWR should never be exceeded.
3. Cargo capacity will be reduced by the addi-
tion of options or passengers, etc.
The loaded vehicle weight, including the snow-
plow system, all aftermarket accessories,
driver, passengers, options, and cargo, must
not exceed either the Gross Vehicle Weight
(GVWR) or Gross Axle Weight (GAWR) ratings.
These weights are specified on the Safety Com-
pliance Certification Label on the driver’s side
door opening.
NOTE:
Detach the snowplow when transporting
passengers.
Vehicle front end wheel alignment was set to
specifications at the factory without consider-
ation for the weight of the plow. Front end toe-in
should be checked and reset if necessary at the
beginning and end of the snowplow season.
This will help prevent uneven tire wear.
The blade should be lowered whenever the
vehicle is parked.
Maintain and operate your vehicle and snow-
plow equipment following the recommendations
provided by the specific snowplow manufac-
turer.
Over The Road Operation With Snowplow
Attached
The blade restricts air flow to the radiator and
causes the engine to operate at higher than
normal temperatures. Therefore, when trans-
porting the plow, angle the blade completely
and position it as low as road or surface condi-
tions permit. Do not exceed 40 mph (64 km/h).
The operator should always maintain a safe
stopping distance and allow adequate passing
clearance.
373