RAM 2015 1500, Operating Information Manual, Page: 264 / 998

When To Use TOW/HAUL Mode
When driving in hilly areas, towing a trailer,
carrying a heavy load, etc., and frequent trans-
mission shifting occurs, press the TOW/HAUL
switch to activate TOW/HAUL mode. This will
improve performance and reduce the potential
for transmission overheating or failure due to
excessive shifting. When operating in TOW/
HAUL mode, transmission upshifts are delayed,
and the transmission will automatically down-
shift (for engine braking) when the throttle is
closed and/or during steady braking maneu-
vers. The “TOW/HAUL Indicator Light” will illuminate
in the instrument cluster to indicate that TOW/
HAUL mode has been activated. Pressing the
switch a second time restores normal operation.
Normal operation is always the default at en-
gine start-up. If TOW/HAUL mode is desired,
the switch must be pressed each time the
engine is started.
WARNING!
Do not use the “TOW/HAUL” feature when
driving in icy or slippery conditions. The
increased engine braking can cause the rear
wheels to slide, and the vehicle to swing
around with the possible loss of vehicle
control, which may cause an accident possi-
bly resulting in personal injury or death.
Torque Converter Clutch
A feature designed to improve fuel economy
has been included in the automatic transmis-
sion on your vehicle. A clutch within the torque
converter engages automatically at calibrated
speeds. This may result in a slightly different
feeling or response during normal operation in
the upper gears. When the vehicle speed drops
or during some accelerations, the clutch auto-
matically disengages.
NOTE:
•
The torque converter clutch will not en-
gage, and the transmission will not shift
into the top overdrive gear, until the trans-
mission fluid and engine coolant are
warm [usually after 1 to 3 miles (2 to 5 km)
of driving]. Because top gear is disabled,
and the engine speed is higher when the
torque converter clutch is not engaged, it
may seem as if the transmission is not
shifting properly when cold. This is nor-
mal. Using the Electronic Range Select
(ERS) shift control, when the transmis-
sion is sufficiently warm, will demon-
strate that the transmission is able to shift
into and out of Overdrive.
•
If the vehicle has not been driven for
several days, the first few seconds of
operation after shifting the transmission
into gear may seem sluggish. This is due
to the fluid partially draining from the
torque converter into the transmission.
TOW/HAUL Switch
261