RAM 2015 1500, Operating Information Manual, Page: 13 / 998

Put the nose side (side opposite of the
emergency key) of the Key Fob against the
ENGINE START/STOP button and push to
operate the ignition switch and with your
foot applied on the brake pedal. Key Fob
Key Fob — If Equipped
The Key Fob operates the ignition switch. Insert
the square end of the key fob into the ignition
switch located on the instrument panel and
rotate to the desired position. It also contains
the Remote Keyless Entry (RKE) transmitter
and an emergency key, which stores in the rear
of the Key Fob.
The emergency key allows for entry into the
vehicle should the battery in the vehicle or the
RKE transmitter go dead. You can keep the
emergency key with you when valet parking.
To remove the emergency key, slide the me-
chanical latch at the top of the Key Fob side-
ways with your thumb and then pull the key out
with your other hand.
NOTE:
When using the emergency key to gain ac-
cess to your vehicle, be aware that the
security alarm may be triggered. Insert the
Key Fob into the ignition and place the
ignition in the ON/RUN mode to disarm the
security system.
KIN Key Fob — If equipped
This KIN Key Fob allows the driver to operate
the ignition switch with the push of a button, as
long as the Remote Keyless Entry (RKE) trans-
mitter is in the passenger compartment. The
Keyless Ignition Node (KIN) has four operating
positions, three of which are labeled and will
illuminate when in position. The three positions
are OFF, ACC, and ON/RUN. The fourth posi-
tion is START, during start RUN will illuminate.
Keyless Ignition Node (KIN)
1 — OFF
2 — ACC (ACCESSORY)
3 — ON/RUN
Emergency Key Removal (IGNM)
10