RAM 1550-8 AK1G, Instructions, Parts And Maintenance Manual, Page: 31 / 52

FORM NO. L-20323-D-0300
1
INSTALLATION
NOTE
The following sections are arranged by model. Verify that you are in the correct section for your model.
FMBES-CC
1. Remove the six Socket Head Cap Screws (Item 11)
and separate the two halves of the FMBES-CC.
2. Using four Socket Head Cap Screws (Item 34) and
Lock Washers (Item 35), secure the Female Pilot
(Item 6) to the motor. Tighten the Socket Head Cap
Screws to the recommended torque (See
Figure 1 and Table 1).
3. Install the customer supplied key into the motor shaft
(See Figure 1).
4. Reassemble the two halves of the FMBES-CC (See
Figure 1).
5. Apply a drop of Loctite
®
242 to the threads of the six
Socket Head Cap Screws (Item 11) (See Figure 1).
6. Reinstall the six Socket Head Cap Screws (Item 11);
then, alternately and evenly tighten them to 65 In. Lbs.
[7.3 N•m] torque (See Figure 1).
7. Remove Pipe Plug (Item 30) (See Figure 1).
8. Tighten the Set Screw (Item 29) to lock the customer
supplied key. Reinstall the Pipe Plug (Item 30) (See
Figure 1).
Motor
Customer
supplied key
6
30
29
11
FIGURE 1
34/35
E U Q R O T D E D N E M M O C E R
L E D O M 4 3 M E T I
5 2 6 ] m • N 5 . 5 6 [ . s b L . t F 3 . 8 4
5 7 8 ] m • N 5 . 5 6 [ . s b L . t F 3 . 8 4
5 2 1 1 ] m • N 0 . 1 6 1 [ . s b L . t F 5 7 . 8 1 1
5 7 3 1 ] m • N 0 . 1 6 1 [ . s b L . t F 5 7 . 8 1 1
TABLE 1
AIR CONNECTIONS
NOTE
For quick response, install a quick exhaust valve and short air lines between the Control Valves and
the FMBES. Align the air inlet port to a down position to allow condensation to drain out of the Air Chamber of the
FMBES.
In high-cyclic applications, Nexen recommends a 50 ms delay between the solenoid valve and the motor starter.
In high-cyclic applications, a 50 ms delay between the solenoid valve and the motor starter is recommended.
FMBES-CC
1. Mark both halves of the FMBES-CC with
an alignment mark prior to disassembly.
with the alignment marks aligned.