82
GETTING TO KNOW YOUR VEHICLE
The outboard ends should be positioned in front of
the cargo tie-down loops.
Cargo Tie Down Loop
TRI-FOLD TONNEAU COVER — IF EQUIPPED
The Tri-Fold Tonneau Cover can be installed on the
truck bed to protect your gear and cargo.
T
RI
-F
OLD
T
ONNEAU
C
OVER
R
EMOVAL
To remove the Tonneau Cover, use the following
steps:
1. Open the tailgate to gain access to the rear
pair of Tonneau Cover clamps located on the
underside of the cover.
Location Of Rear Clamps
NOTE:
If clamp wire is damaged replace immediately.
2. Pull both clamp handles down to release the
Tonneau Cover’s rear panel.
Released Position
3. From the released position, send the clamps
to the Stowed Position by pushing from the
yellow bumper up.
Stowed Position
4. Fold the rear panel up onto the center panel
(intermediate position).
CAUTION!
Make sure the Tonneau Cover clamp and clamp
wire are in the proper stowed position. If the
clamp and clamp wire are not properly stowed,
damage to the Tonneau Cover material will
result.
22_DS_OM_EN_USC_t.book Page 82
Summary of Contents for 1500 CLASSIC 2022
Page 90: ...88 GETTING TO KNOW YOUR INSTRUMENT PANEL BASE INSTRUMENTCLUSTER 22_DS_OM_EN_USC_t book Page 88...
Page 360: ......
Page 361: ......
Page 362: ......