RAM 1500 CLASSIC 2022, Owner'S Manual, Page: 264 / 364

262 IN CASE OF EMERGENCY
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Shift the transmission into Park (P).
5. Turn the ignition OFF.
6. Block both the front and rear of the wheel
diagonally opposite the jacking position. For
example, if the driver’s front wheel is being
changed, block the passenger’s rear wheel.
Wheel Blocked
NOTE:
Passengers should not remain in the vehicle when
the vehicle is being lifted or raised.
J
ACK
L
OCATION
The jack and jack tools are stored under the front
passenger seat.
R
EMOVAL
O
F
J
ACK
A
ND
T
OOLS
To access the jack and jack tools, you must remove
the plastic access cover located on the side of the
front passenger’s seat. To remove the cover, pull
the front part of the cover (closest to the front of
the seat) toward you to release a locking tab. Once
the front of the cover is loose, slide the cover
toward the front of the seat until it is free from the
seat frame.
Jack Access Cover
Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then
slide the assembly out from under the seat.
Jack And Tools
Release the tool bag straps from the jack and
remove tools from bag.
Jack And Tool Bag
22_DS_OM_EN_USC_t.book Page 262