14
GETTING TO KNOW YOUR VEHICLE
Key Fob For Standard Ignition
NOTE:
Inserting the key fob with integrated key into the
ignition switch disables the system from
responding to any button pushes from that key
fob. Driving at speeds 5 mph (8 km/h) and
above disables the system from responding to
all key fob buttons for all key fobs.
To Lock/Unlock The Doors And Tailgate
Push and release the unlock button on the key
fob once to unlock the driver’s door, or, twice
within five seconds to unlock all doors, the
tailgate and the RamBox (if equipped). To lock
all the doors and the tailgate, push the lock
button once.
When the doors are unlocked, the turn signals
will flash and the illuminated entry system will
be activated. When the doors are locked, the
turn signals will flash and the horn will chirp.
All doors can be programmed to unlock on the
first push of the unlock button. The horn chirp
when the lock button is pushed can be
programmed on/off within Uconnect Settings
Replacing The Battery In The Key Fob
The replacement battery is one CR2032
battery.
NOTE:
Customers are recommended to use a
battery obtained from Mopar. Aftermarket
coin battery dimensions may not meet the
original OEM coin battery dimensions.
Perchlorate Material — special handling may
apply. See www.dtsc.ca.gov/hazard
ouswaste/perchlorate for further informa
-
tion.
Do not touch the battery terminals that are
on the back housing or the printed circuit
board.
1 — PANIC Button
2 — Unlock Button
3 — Lock Button
4 — Remote Start Button
5 — Emergency Key Location
21_DS_OM_EN_USC_t.book Page 14
