GETTING TO KNOW YOUR VEHICLE
41
To Activate
1. The Automatic High Beams are enabled
through the Uconnect system. Refer to
“Uconnect Settings” in “Multimedia” for
further information.
2. Turn the headlight switch to the AUTO
headlight position.
3. Push the multifunction lever away from you
(toward front of vehicle) to engage the high
beam mode.
NOTE:
The Automatic High Beams will not activate until
the vehicle is at or above 12 mph (20 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or
rearward in vehicle) to manually deactivate
the system (normal operation of low beams).
2. Push back on the multifunction lever to
reactivate the system.
The Automatic High Beams can also be
deactivated through the Uconnect system. Refer to
“Uconnect Settings” in “Multimedia” for further
information.
F
LASH
-T
O
-P
ASS
You can signal another vehicle with your headlights
by lightly pulling the multifunction lever toward you.
This will cause the high beam headlights to turn on,
and remain on, until the lever is released.
A
UTOMATIC
H
EADLIGHTS
— I
F
E
QUIPPED
This system automatically turns the headlights on
or off according to ambient light levels. To turn the
system on, rotate the headlight switch
counterclockwise to the AUTO position. When the
system is on, the headlight time delay feature is
also on. This means the headlights will stay on for
up to 90 seconds after you place the ignition into
the OFF position. The headlight time delay can be
programmed 0/30/60/90 seconds. Refer to
“Uconnect Settings” in “Multimedia” for further
information.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the headlights
will turn on in the Automatic Mode.
P
ARKING
L
IGHTS
A
ND
P
ANEL
L
IGHTS
To turn on the parking lights and
instrument panel lights, rotate the
headlight switch clockwise. To turn off
the parking lights, rotate the headlight switch back
to the O (off) position.
H
EADLIGHTS
O
N
W
ITH
W
IPERS
(A
VAILABLE
W
ITH
A
UTOMATIC
H
EADLIGHTS
O
NLY
)
When this feature is active, the headlights will turn
on approximately 10 seconds after the wipers are
turned on if the headlight switch is placed in the
AUTO position. In addition, the headlights will turn
off when the wipers are turned off, if they were
turned on by this feature.
NOTE:
This feature can be programmed through the
Uconnect system. Refer to “Uconnect Settings” in
“Multimedia” for further information.
2
20_DS_OM_EN_USC_t.book Page 41
