RAM 1500 2019, User Manual

Page: 35 / 340

2. Turn the headlight switch to the AUTO
headlight position.
3. Push the multifunction lever away from
you (toward front of vehicle) to engage the
high beam mode.
NOTE:
The Automatic High Beams will not activate
until the vehicle is at or above 12 mph
(20 km/h).
To Deactivate
1. Pull the multifunction lever toward you (or
rearward in vehicle) to manually deacti-
vate the system (normal operation of low
beams).
2. Push back on the multifunction lever to
reactivate the system.
The Automatic High Beams can also be de-
activated through the Uconnect system. Re-
fer to “Uconnect Settings” in “Multimedia”
in the Owner’s Manual for further informa-
tion.
Flash-To-Pass
You can signal another vehicle with your
headlights by lightly pulling the multifunc-
tion lever toward you. This will cause the high
beam headlights to turn on, and remain on,
until the lever is released.
Automatic Headlights
This system automatically turns your head-
lights on or off based on ambient light levels.
To turn the system on, turn the headlight
switch to the extreme clockwise position
aligning the indicator with the AUTO on the
headlight switch. When the system is on, the
Headlight Time Delay feature is also on. This
means your headlights will stay on for up to
90 seconds after you turn the ignition switch
OFF. To turn the Automatic System off, turn
the headlight switch counterclockwise to the
O (off) position.
NOTE:
The engine must be running before the head-
lights will come on in the Automatic mode.
Parking Lights And Panel Lights
To turn on the parking lights and
instrument panel lights, from the
O (off) position, rotate the head-
light switch clockwise to the first
detent. To turn off the parking
lights, rotate the headlight switch back to the
O (off) position.
Headlights On With Wipers
(Available With Automatic
Headlights Only)
When this feature is active, the headlights
will turn on approximately 10 seconds after
the wipers are turned on if the headlight
switch is placed in the AUTO position. In
addition, the headlights will turn off when the
wipers are turned off, if they were turned on
by this feature.
NOTE:
This feature can be programmed through the
Uconnect system. Refer to “Uconnect Set-
tings” in “Multimedia” in the Owner’s
Manual for further information.
33