RAM 1500 2019, User Manual

Page: 183 / 340

standard Backup Camera view. If the vehicle
is then returned to REVERSE gear from NEU-
TRAL or DRIVE, the Zoom View selection will
automatically resume.
If the vehicle is in PARK, Zoom View is
available until the gear selector is placed in
DRIVE or REVERSE and speeds are at or
above 8 mph (13 km/h).
NOTE:
• If the vehicle in is DRIVE, NEUTRAL, or
REVERSE, and speed is greater than or
equal to 8 mph (13 km/h), Zoom View is
unavailable and the icon will appear grey.
• While in Zoom View, the guidelines will not
be visible.
SURROUND VIEW CAMERA SYSTEM —
IF EQUIPPED
Your vehicle may be equipped with the Sur-
round View Camera System that allows you to
see an on-screen image of the surroundings
and top view of your vehicle whenever the
gear selector is put into REVERSE or a differ-
ent view is selected through the "on screen
soft buttons". The top view of the vehicle will
show which doors are open. The image will be
displayed on the touchscreen display along
with a caution note “Check Entire Surround-
ings” across the top of the screen. After five
seconds, this note will disappear. The Sur-
round View Camera System is comprised of
four sequential cameras located in the front
grille, rear liftgate and side mirrors.
NOTE:
The Surround View Camera System has pro-
grammable settings that may be selected
through the Uconnect System. Refer to
“Uconnect Settings” in “Multimedia” in your
Owner’s Manual for further information.
When the vehicle is shifted into REVERSE,
the rear camera view and top view is the
default view of the system (Automatic Activa-
tion).
When the vehicle is shifted out of REVERSE
(with camera delay turned on), the camera
image will continue to be displayed for up to
10 seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK or
the ignition is switched to the OFF position.
There is a touch screen button (X) to disable
the display of the camera image.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the surround
view camera mode is exited and the last
known screen appears again.
While the “rear view” is displayed, and if
enabled, active guide lines are overlaid on the
image to illustrate the width of the vehicle,
including the side view mirrors and its pro-
jected backup path based on the steering
wheel position.
Different colored zones indicate the distance
to the rear of the vehicle.
Modes Of Operation
Standard Backup Camera view can be manu-
ally activated by selecting “Backup Camera”
through the Controls menu within the
Uconnect screen.
Refer to “Parkview Rear Back Up Camera —
If Equipped” in this section for more infor-
mation on activation conditions.
181