RAM Commercial ProMaster 2024, Owner'S Manual, Page: 45 / 284

Turn the adjuster wheel to the right or left to adjust the
height of the armrest up or down.
HEAD RESTRAINTS
Head restraints are designed to reduce the risk of injury
by restricting head movement in the event of a rear
impact. Head restraints should be adjusted so that the
top of the head restraint is located above the top of
your ear.
WARNING!
•
All occupants, including the driver, should not oper-
ate a vehicle or sit in a vehicle’s seat until the
head restraints are placed in their proper positions
in order to minimize the risk of neck injury in the
event of a crash.
•
Head restraints should never be adjusted while the
vehicle is in motion. Driving a vehicle with the head
restraints improperly adjusted or removed could
cause serious injury or death in the event of a
collision.
Front Head Restraint Adjustment
To raise the head restraint, pull upward on the head
restraint. To lower the head restraint, push the adjust-
ment button located on the base of the head restraint
and push downward on the head restraint.
NOTE:
Do not reposition the head restraint 180 degrees to the
incorrect position in an attempt to gain additional clear-
ance to the back of the head.
Front Head Restraint Removal
To remove the head restraint, raise it up as far as it can
go. Then, push the adjustment button and the release
button at the base of each post while pulling the head
restraint up. To reinstall the head restraint, push the
adjustment button and the release button at the base
of each post and put the head restraint posts into the
holes. Then, adjust it to the appropriate height.
NOTE:
Do not reposition the head restraint 180 degrees to the
incorrect position in an attempt to gain additional clear-
ance to the back of the head.
WARNING!
•
A loose head restraint thrown forward in a collision
or hard stop could cause serious injury or death to
occupants of the vehicle. Always securely stow
removed head restraints in a location outside the
occupant compartment.
•
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the preceding reinstallation instructions prior to
operating the vehicle or occupying a seat.
Rear Adjustment — If Equipped
The outboard and center head restraints are adjustable
and removable. To raise the head restraint, push and
hold the adjustment button, located on the base of the
head restraint and pull upward on the head restraint. To
lower the head restraint, push and hold the adjustment
button, and push downward on the head restraint till
the desired height is reached.
Adjuster Wheel
Adjustment Buttons
1 — Release Button
2 — Adjustment Button
GETTING TO KNOW YOUR VEHICLE 43
2