RAM Commercial ProMaster 2024, Owner'S Manual, Page: 39 / 284

NOTE:
•
After pushing the door handle button, you must wait
two seconds before you can lock or unlock the
doors, using either Passive Entry door handle. This
is done to allow you to check if the vehicle is locked
by pulling the door handle without the vehicle
unlocking.
•
The Passive Entry system will not operate if the key
fob battery is depleted.
○
When the key fob battery is low, the instrument
cluster will display a message indicating that the
key fob battery is low
page 269.
POCKET DOOR (BEV MODELS) —
IF EQUIPPED
Push the lock button on the instrument panel. The indi-
cator light will illuminate to show the doors are locked.
Push the lock button on the instrument panel a second
time to unlock the doors.
To open from the inside, pull the inside door handle
towards the rear of the vehicle.
ROLL-UP DOOR — IF EQUIPPED
Unlocking the Rear Roll-Up Door
Unlock the rear roll-up door by pressing the unlock but-
ton the key fob.
Opening From The Outside
To open from the outside, pull up on the exterior roll-up
door handle. This will release the door from the side
stop latches.
Lift the door about halfway, then push from the bottom
of the door upwards to the fully open position.
Opening From The Inside
To open from the inside, push down on the latch
release mechanism with either your hand or your foot.
Pull up on the interior roll-up door flange or pull up
using the door strap.
Lift the door about halfway, then push from the bottom
of the door upwards to the fully open position.
Push The Door Handle Button To Lock
Interior Pocket Door Handle
Exterior Roll-up Door Handle
1 — Exterior Roll-Up Door Handle
2 — Exterior Roll-Up Door Flange Handle
GETTING TO KNOW YOUR VEHICLE 37
2