
WARNING!
•
Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Allowing children to
be in a vehicle unattended is dangerous for a num-
ber of reasons. A child or others could be seriously
or fatally injured. Children should be warned not to
touch the parking brake, brake pedal or the gear
selector.
•
Do not leave the key fob in or near the vehicle, or
in a location accessible to children, and do not
leave the Keyless Enter ‘n Go™ Ignition in the
ON/RUN position. A child could operate power win-
dows, other controls, or move the vehicle.
•
Driving with the rear doors open can allow poison-
ous exhaust gases into your vehicle. You and your
passengers could be injured by these fumes. Keep
the rear doors closed when you are operating the
vehicle.
•
If you are required to drive with the rear doors
open, make sure that all windows are closed and
the climate control blower control is set to a high
speed. DO NOT use the recirculation mode.
CAUTION!
An unlocked vehicle is an invitation for thieves.
Always remove the key fob from the vehicle and lock
all of the doors when leaving the vehicle unattended.
AUTO UNLOCK DOORS —
IF EQUIPPED
This feature unlocks all front doors when one front door
is opened.
NOTE:
If the rear or side door is open, only the rear or side
door is unlocked. The Auto Unlock Doors feature can be
enabled within the Uconnect settings.
KEYLESS ENTER ‘N GO™ —
PASSIVE ENTRY
The Passive Entry system is an enhancement to the
vehicle’s key fob and a feature of Keyless Enter ‘n Go™
— Passive Entry. This feature allows you to lock and
unlock the vehicle’s door(s) without having to push the
key fob lock or unlock buttons.
NOTE:
•
Passive Entry may be programmed on or off within
Uconnect Settings
•
The key fob may not be detected by the vehicle Pas-
sive Entry system if it is located next to a mobile
phone, laptop, or other electronic device; these
devices may block the key fob’s wireless signal and
prevent the Passive Entry system from locking/
unlocking the vehicle.
•
Passive Entry Unlock initiates illuminated approach
(low beams, license plate lamp, position lamps) for
whichever duration is set between 0, 30, 60 or
90 seconds. Passive Entry Unlock also initiates two
flashes of the turn signals.
•
If the vehicle is unlocked by Passive Entry and no
door is opened within 60 seconds, the vehicle will
relock and (if equipped) will arm the Vehicle Security
system.
To Unlock From The Driver, Passenger or Rear Door
With a valid Passive Entry key fob within 5 ft (1.5 m) of
the door handle, push the Passive Entry button next to
the handle to unlock the vehicle.
•
Unlock the front doors only if the Uconnect setting is
set to "Approach" and you press the button located
next to the front handle.
•
Unlock the cargo area doors only if the Uconnect
setting is set to "Approach" and you press the button
located next to the rear handle.
•
The Passive Entry feature will be disabled if the
Uconnect setting is set to "Off".
NOTE:
•
Either the cargo area and cabin compartment or all
doors will unlock when you press Passive Entry but-
ton, depending on the selected setting in the
Uconnect system
To Lock The Vehicle’s Doors
With one of the vehicle’s Passive Entry key fobs within
5 ft (1.5 m) of either front door handle, pushing the
Passive Entry lock button will lock the vehicle.
36
GETTING TO KNOW YOUR VEHICLE
Summary of Contents for ProMaster 2024
Page 66: ...GETTING TO KNOW YOUR INSTRUMENT PANEL BASE MIDLINE INSTRUMENT CLUSTER 64...
Page 68: ...PREMIUM INSTRUMENT CLUSTER 66 GETTING TO KNOW YOUR INSTRUMENT PANEL...
Page 281: ......
Page 282: ......