RAM Commercial ProMaster 2024, Owner'S Manual, Page: 204 / 284

CAUTION!
can also result in sealant contacting internal Tire
Service Kit components which may cause perma-
nent damage to the kit.
(D) Drive Vehicle:
Immediately after injecting sealant and inflating the
tire, drive the vehicle 5 miles (8 km) or 10 minutes to
ensure distribution of the Tire Service Kit Sealant within
the tire. Do not exceed 50 mph (80 km/h).
WARNING!
Tire Service Kit is not a permanent flat tire repair.
Have the tire inspected and repaired or replaced after
using Tire Service Kit. Do not exceed 50 mph
(80 km/h) until the tire is repaired or replaced. Fail-
ure to follow this warning can result in injuries that
are serious or fatal to you, your passengers, and oth-
ers around you.
(E) After Driving:
Pull over to a safe location page 200.
1. Push in the Mode Select Knob and turn to the Air
Mode position.
2. Uncoil the power plug and insert the plug into the
vehicle's 12 Volt power outlet.
3. Uncoil the Air Pump Hose (black in color) and screw
the fitting at the end of hose onto the valve stem.
4. Check the pressure in the tire by reading the Pres-
sure Gauge.
If tire pressure is less than 19 psi (1.3 Bar):
The tire is too badly damaged. Do not attempt to drive
the vehicle further. Call for assistance.
If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button to turn on Tire Service Kit
and inflate the tire to the pressure indicated on the
tire and loading information label on the driver-side
door opening.
NOTE:
If the tire becomes overinflated, push the Deflation
Button to reduce the tire pressure to the recom-
mended inflation pressure before continuing.
2. Disconnect the Tire Service Kit from the valve stem,
reinstall the cap on the valve stem and unplug from
12 Volt outlet.
3. Place the Tire Service Kit in its proper storage area
in the vehicle.
4. Have the tire inspected and repaired or replaced at
the earliest opportunity at an authorized dealer or
tire service center.
5. Remove the Speed Limit sticker from the instrument
panel after the tire has been repaired.
6. Replace the Sealant Bottle and Sealant Hose
assembly at an authorized dealer as soon as pos-
sible
page 202.
NOTE:
When having the tire serviced, advise the authorized
dealer or service center that the tire has been sealed
using the Tire Service Kit.
(F) Sealant Bottle And Hose
Replacement:
1. Replace the Tire Service Kit Sealant Bottle and Seal-
ant Hose prior to the expiration date (printed at the
upper right hand corner on the bottle label) to
assure optimum operation of the system
page 202.
2. Uncoil the Sealant Hose (clear in color).
3. Locate the red colored round Sealant Bottle release
button at the lower right hand corner of the kit.
4. Push and hold the Sealant Bottle release button,
then pull out the bottle holding the button.
5. Clean any remaining sealant from the Tire Service
Kit housing.
6. Position the new Sealant Bottle in the housing so
that the Sealant Hose aligns with the hose slot in
the front of the housing. Push and hold the Sealant
Tire Service Kit Sealant Expiration Date Location
202 IN CASE OF EMERGENCY