RAM Commercial ProMaster 2024, Owner'S Manual, Page: 191 / 284

JACKING AND TIRE CHANGING —
IF EQUIPPED
Use this QR code to access your digital
experience.
WARNING!
•
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
•
Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack. If you need to get
under a raised vehicle, take it to a service center
where it can be raised on a lift.
•
Never start or run the engine while the vehicle is
on a jack.
•
The jack is designed to be used as a tool for
changing tires only. The jack should not be used to
lift the vehicle for service purposes. The vehicle
should be jacked on a firm level surface only. Avoid
ice or slippery areas.
PREPARATIONS FOR JACKING
1. Park the vehicle on a firm, level surface. Avoid ice or
slippery areas.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid being hit when operating the jack or
changing the wheel.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake firmly.
4. Place the transmission in PARK (P) or REVERSE (R)
for manual transmission.
5. Turn the ignition OFF.
6. Block both front and rear of the wheel diagonally
opposite of the jacking position. For example, if the
driver’s front wheel is being changed, block the pas-
senger’s rear wheel.
NOTE:
Passengers should not remain in the vehicle when the
vehicle is being lifted or raised.
JACK AND TOOLS LOCATION
Depending on vehicle trim level, the jack and tools are
stored under the front passenger seat in a box, or
strapped behind the driver seat in a tool bag. Tools may
vary.
Scan me
Wheel Blocked Example
Jack Tool Bag Location — If Equipped
Jack Kit Location — If Equipped
IN CASE OF EMERGENCY 189
7