RAM Commercial ProMaster 2024, Owner'S Manual, Page: 110 / 284

driver stops providing input to the steering wheel, the
system will require a few seconds to fully resume lane
centering assistance, especially during curves.
WARNING!
The Active Driving Assist (ADA) system is a conve-
nience system. It is not a substitute for active driver
involvement. It is always the driver’s responsibility to
be attentive of road traffic, weather conditions,
vehicle speed, distance to the vehicle ahead, position
in the lane compared to other vehicles, and brake
operation to ensure safe operation of the vehicle
under all road conditions. Your complete attention is
always required while driving to maintain safe control
of your vehicle. Failure to follow these warnings can
result in a collision and death or serious personal
injury.
You should not utilize the ADA system:
•
When driving in complex driving situations (e.g.
urban environments, construction zones, etc.),
adverse weather or low visibility conditions (e.g.
rain, snow, fog, sleet, dust), or adverse road condi-
tions (e.g. heavy traffic, worn or missing lane mark-
ings, etc.).
•
When entering a highway on-ramp or exiting an
off-ramp, when driving on roads that are icy, snow
covered, or slippery.
•
When circumstances do not allow safe driving at a
constant speed.
TURNING ACTIVE DRIVING ASSIST
ON OR OFF
To enable the Active Driving Assist system, proceed as
follows:
1. Push the Active Driving Assist on/off button located
on the right side of the steering wheel. The steering
wheel image will display white in the instrument
cluster display until the system is engaged. If ACC
was previously turned off, pushing this button will
activate just the lane centering feature of the ADA
system. Push the ACC button to activate both ACC
and ADA Systems.
2. If ACC was active and engaged before pushing the
ADA on/off button, ACC will remain engaged and
ADA will become enabled and then engaged (once
all other conditions are met).
3. If ACC was not enabled before pushing the ADA
on/off button, push the SET
(+)
button or the SET
(-)
button and release when the desired driving speed
is shown in the instrument cluster display.
4. If desired, adjust the ACC distance setting by push-
ing the Distance Setting button.
When all system conditions are met as described in
“System Engagement Conditions” in the next section,
the system will engage and the steering wheel image in
the display will change to green.
NOTE:
Along with the color change of the steering wheel
image, the glow effect of the instrument cluster display
will also change to green when ADA is engaged.
System Engagement Conditions
The following conditions must be met before the system
will engage:
•
Active Driving Assist system is enabled
•
ACC is active
•
Driver seat belt is buckled
•
System detects visible lane markings
•
Vehicle is traveling below 93 mph (150 km/h)
•
Vehicle is centered in lane
•
Turn signal is not activated
Active Driving Assist On/Off Button
Active Driving Assist Engaged (Steering Wheel Green)
108 STARTING AND OPERATING