Raleigh Pedelec Impulse, Original Manual

Page: 14 / 206

I General User Manual 13
Make sure you fit or screw in the pedals straight, as
otherwise you could damage the thread in the crank
arm beyond repair.
1 MTB system pedals
2 Touring or sports pedals
3 Road bike system pedals
1
2
3
Only use the designated cleats and shoes for MTB,
racing and system pedals. If you use other cleats/
shoes you may slip out of the pedals.
Riders who are inexperienced in the use of MTB system
pedals or road system pedals, also referred to as click
pedals, are vulnerable to falls with potentially serious
consequences. If you use system pedals, practise clicking
into the pedal and releasing the shoe from the pedal when
the bike is stationary. Never practise this in road traffic.
Read the user manual of the pedal and shoe manufacturer.
You can also find more information on this subject in
the Internet. A list of links is provided in
➠
Chapter 29
"Link list" .
9.2 Adjusting the seat position
9.2.1 Adjusting the bike saddle
The seat position is decisive for your well-being and cy-
cling performance.
›
Do not remove or change the seatpost or saddle
clamp. If you change or modify components, this
renders the warranty invalid.
›
Tighten all screws to the prescribed torque as
otherwise screws could shear off and compo-
nents could come loose or detach altogether (see
➠
Chapter 30 "Technical data" ).
Only work on the bike if you have the correct tools
and requisite knowledge. Always have complex or
safety-relevant work carried out by a specialist cycle
shop.
9.2.2 Operating the quick-release device
›
All quick-release devices must be tightened se-
curely before you set off. Check this before every
journey.
›
If you leave your bike unattended, check that all
quick-release devices are correctly secured be-
fore setting off again.
›
When closing the quick-release lever to lock it,
it must be necessary to apply a force that causes
you to make a fist with your hand as otherwise
the quick-release device could come loose.