Raleigh Pedelec Groove 2.0, User Manual, Page: 148 / 321

20 Original User Manual | Pedelec Impulse 2.0 Ergo
Battery in the docking station
SEAT TUBE BATTERY
If a charging fault occurs, the LED (where present)
in the charger flashes red. In this case, the charging
current is too high. Disconnect the battery from the
charger and then connect it again. If the error mes-
sage still appears, the battery and charger must be
checked by a specialist cycle shop.
7 Control unit and display
The Pedelec Impulse 2.0 Ergo can be controlled via two
elements: the control unit on the handlebar grip and the
display in the middle of the handlebar.
7.1 Control unit
1 button
2 button
3 button
4 button
1
2
3
4
Press the button to switch the system on and off. But-
tons 2 to 4 have different functions depending on the
menu item you have selected.
7.1.1 Switching on/off
Press the button on the control unit to switch the Im-
pulse system on. After a few seconds, the welcome screen
appears, followed by the start menu. From there you can
carry out further settings
➠
Chapter 1.1 “General” .
After switching on, the system is always in the same
display mode as when you last switched it off.
To switch your Pedelec off, press the button on the con-
trol unit in the start menu.
7.1.2 Pushing assistance
The pushing assistance moves the Pedelec slowly (at a
maximum speed of 6 km/h) without you having to turn the
pedals, e.g. if you are manoeuvring in a tight space or are
pushing your Pedelec out of a basement garage.
To activate the pushing assistance, press the button for
three seconds.
The pushing assistance is not suitable for use as
starting assistance.
7.1.3
/
buttons
•
You can specify the power-assist level via the
/ buttons.
•
Each time you press one of these two buttons, the
power assist changes by one level. If you press the
button once, the level of assistance increases by
one level. If you press the button once, the as-
sistance becomes weaker by one level.