17
2021 RALE® ST120 INSTALLATION GUIDE
CAUTION
Route and restrain the brake line to avoid contact with any
moving or potentially hot parts. Allow enough slack for the RALE
Track Kit to move freely through the stroke, and the handlebars
to turn unrestrained.
1. Remove the OEM front brake master cylinder and lever from the
handlebar.
2. The RALE brake system is pre-bled.
3. Install the brake caliper to the mount using the provided caliper
bolts and blue Loctite® 243. Torque to 160 IN-LB.
4. Disconnect the brake line at the master cylinder. Do not pull the
brake lever while the line is disconnected.
5. Mount the master cylinder and lever to the handlebars. Feed the
line up though the frame of the bike to the master cylinder and
reconnect it.
6. The RALE Track Kit brake system may need to be bled again.
TIP:
If the brake lever doesn’t have a firm pull after reconnecting
the brake line, place a zip tie or rubber band around the lever and
handlebar overnight. This may remove any air from the system.
B
r a k e
i
n S Ta l l aT i o n
