MTR 221 ACS - MTR 221 ACS DHHS
MANUALE ISTRUZIONI / INSTRUCTION MANUAL
E
LECTRONIC
S
YSTEM
49
Model R 221 ACS - R 221 ACS DHHS
MT
R
2
21
ACS
-
MTR
2
21
AC
S DHH
S - Electronic Syste
m
JP14 - A
DDITIONAL
RESISTANCE
OFF: standard input
ON: used to power a retro-reflective photocell
JP8, JP9, JP10, JP11, JP12, JP13 - Operation mode selection
JP8 - T
IME
RENEW
MODE
OFF: Standard
ON: the timer operates in the time renew mode. When the button is
pressed the time is renewed without the LED OFF (if the LED is already
ON, continues to stay ON but with renewed time). The same is
applicable for the laser if is independent.
JP9 - L
ASER
CONTROLLED
INDEPENDENTLY
OFF: Standard
ON: When the button, placed on J5, is pressed the laser switches ON
independently from the light.
JP11, JP10* - T
IME
MANAGEMENT
*
Only in mode 4.00 JP10 takes the function of
exclusion of auto-turning off LED (designed for
temperature)
JP10 - A
UTO
-
SHUTDOWN
E
XCLUSION
OFF, OFF: 30 seconds
ON, OFF: 45 seconds
OFF, ON: 60 seconds
ON, ON: power supply (maximum light ON time is 15 min. for safety
reasons).
JP10 - LED auto shutdown exclusion, available in s.w. 4.00 only
JP12, JP13 - S
OFTWARE
CONFIGU
-
RATION
OFF, OFF: s.w.2.00 (standard) - it is possible to use the encoder
management to switch ON/OFF the laser and LED
ON, OFF: s.w.3.01 - power supply without any safety and shutdown
time.
OFF, ON: s.w.5.00 with the LED off, pressing the button only turns on
the LED and the fan.
If the button is pressed again within 5 seconds, the laser also lights up.
Pushing the button after the first 5 seconds, everything will switch off
The LED and eventually the laser switch off anyway when the time set
with the trimmer has set
(in this mode it is possible to use the encoder management to switch on
light / laser).
ON, ON: s.w.4.00 (following the button, the switching on of the board is
controlled by closing the contact)
If the board is configured as JP8 standard:
OFF:( pushing the button the status will change) (if on will switch off and
the other way around)
ON: The board works in renewal time mode. In this mode, each time the
button is pressed, the ignition time is renewed without switching off the
light.
If the light is already on, it continues to stay on but with renewed time.
Also applies to the laser if independent
F
AN
The fan switches ON together with the LED, and operates 15 seconds
longer after the LED OFF.
Trimmers
TR1- C
URRENT
C
ONTROL
Adjust the output current intensity to the LED.
Step-less current adjustment from 0 to 4.8 A.
-> Luxeon V LED - adjust current to ~ 2.2 A.
LEDs
