USER’S MANUAL
1000VA/1500VA/2000VA/3000VA
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important safety instructions. Please follow all instructions carefully during installation.
Read this manual thoroughly before attempting to unpack, install or operate.
CAUTION-
To prevent the risk of fire or electric shock, install in a temperature and humidity controlled
indoor area, free of conductive contaminants.
CAUTION-
Risk of electric shock, do not remove the cover. No user serviceable parts. Refer servicing
to qualified service personnel.
CAUTION-
Risk of electric shock, hazardous live parts inside this UPS
can be energized from the battery supply even when the
input AC power is disconnected.
CAUTION-
Risk of electric shock, Battery Circuit is not isolated from AC
input; hazardous voltage may exist between battery
terminals and ground. Test before touching.
WARNING-
This is a Class A-UPS Product. In a domestic environment,
this product may cause radio interference, in which case,
the user may be required to take additional measures.
NOTICE-
The UPS is designed to be for use with computer loads only.
NOTICE-
To prevent injury, do not carry with the handle of front cover
when moving the UPS.
SETUP
1 Inspection
Inspect the UPS upon receipt. Notify the carrier
and dealer if there is damage. The package is
recyclable; save it for reuse or dispose of it
properly.
2 Place the UPS properly
3 Connect the loads
First, connect the UPS with Utility, then plug the
loads into the outlets on the rear of the UPS. To
use the UPS as a master “On/Off” switch, make
sure that all of the loads are switch “On”.
These UPS outlets provide battery power and
surge protection to the equipment when utility
voltage is outside acceptable limits.
Caution:
Do not connect a laser printer to the
UPS outlets.
4 Connect
Computer
Interface Port
Connect the supplied interface cable (RS-232 or
USB, Optional) to the interface port on the rear of
the UPS and the computer interface port. See
software installation guide in the CD-ROM
(Optional) for installation purpose.
5 Connect
Network
Surge protection
Connect a 10 base-T / 100 base-T network cable
into the RJ-45 network surge protection “IN” jack
on the rear of the UPS. Connect from the “OUT”
jack with network cabling to network equipment.
6 UPS Start Up
1. Connect the UPS to the wall receptacle and wait approximately 5-6 seconds, Amber LED should
flash to indicate charging.
2. Push the “On” Switch on the front panel of the UPS until Buzzer sounds, then release.
3. The LCD Display lights up along with an LED. If Utility is normal, the UPS will run under Utility
mode (Green LED). On the contrary, the UPS will run under Backup mode (Solid Amber LED) and
the buzzer alarms every 2 seconds in case of blackout or over/under voltage.
Caution:
1. The UPS “On” will not be executed if the above procedure is not done completely, which means
the buzzer has commenced to sound.
2. The UPS will remain at “NO” output, if the start-up operation is not proceeded properly even
though the Input Power Cord is connected to the wall receptacle.
IMPORTANT NOTICE:
Plug the UPS into the wall receptacle to charge the UPS for over 8 hours after initial installation.
STORAGE:
Store at -15 to +30
°
C (+5 to +86
°
F), charge the UPS battery every six months.
Store at +30 to +45
°
C (+86 to +113
°
F), charge the UPS battery every three months.
192321362000004
IN
O U T
