RAK8 Motherboard Instruction Manual
For programming information see “RAK8 wired/wireless programming guide”
Overview:
The RAK8 Motherboard forms the base for up to 8 pluggable modules which can be added
in any combination according to system requirements. Compatible pluggable modules to be
used with the RAK8 motherboard are:
WMT-400
- 400W Trailing edge dimmer
WML-400
- 400W Leading edge dimmer
WDA-600
- 600W digital dimmer for use with 1-10V, DSI and DALI broadcast
WMS-600
- 600W Switching module
WM-CUB
- Twin relay curtain and blind controller
RAK8s, combined with a Link device (RX-Link or RAKLink) can either be used as a single 8
channel unit or formed into a “stack”. RAK8s can be also be used in combined stacks with
other Rako RAK units (RAK4-T, RAK4-F, RAK4-R) on the same Link device.
Before commencing installation of a Rako product first read this instruction manual carefully.
Rako Controls Ltd accepts no responsibility for any damage or injury caused by incorrect
installation of a Rako product.
Installation should only be carried out by a qualified electrician. Always install RAK8 units in
a well ventilated room, with a minimum clearance of 50mm at the sides in the correct
orientation i.e. vents top and bottom. Each RAK-4 unit must be earthed.
Wireless system (RX-Link):
