How to config network parameters and Pair the Module
This document is only using for Flylink HD .
Flylink HD : RAK566(TX) and RA554(RX).
RAK5610 is same with RAK554 including firmware and Hardware.
1 RAK554 PIN Definition
2 RAK554 Dip switch definition
There are 6 group Dial-up in the module . ON direction is showing low-level ,marked as 0.
When The Dial-up is on the opposite direcetion ,that is showing high-level,marked as 1 .
The dial-up flag order is 1-6,marked as sw1-6.
The function definition is followed ：
Sw6
Sw5
Band
Channel
Band
1
1
4
149
5745
1
0
1
48
5240
0
1
1
36
5180
0
0
4
165
5825
The default band is Band4. That is to say channel 149.
Sw1 is using for WPS function . If you want to use this function , you need do the following
steps.
Step1 : Whatever the SW1 level , set SW1 into low-level more than 1 second .
Step2 : Then Set SW1 into high-level .
Step3 : The Wifi light will blink.that is showing you have step into the WPS mode.
After power on the module,please scan the AP： FS_5G_AP_xxxxxx or
Flylink_xxxxxx
（
please
make sure your smartphone supporting 5G SSID
）. X means MAC address.
