RAID N8103-134, Setup Manual

Page: 56 / 80

856-127900-408- B
55
1. Creating Logical Drives
This section describes the creation of a logical drive on SuperBuild Utility. Refer to User’s Guide in
“N8103-134/135/128/G128 RAID Controller Management Software” CD” for detail.
1-1. Job Flow of Creation of Logical Drives
When more than 2 RAID controller
are installed, please choose the
RAID controller which choose
* [Controller Selection] and builds a
RAID system.
Delete Disk Array?
Start SuperBuild Utility
Start creation of RAID system
Are there existing Disk
Array?
Are Disk Arrays
Are there existing
Logical Drive?
Are Logical Drive
added?
Initialization to Created Logical
Drive
Reboot system
End creation of RAID System
Creating Disk Array
Creating Logical
Drive
Deleting Logical
Drive
Deleting Disk Array
* [Disk Array Management]
→
[Create Disk Array]
Refer to 3-2 [Creating Disk
Array]
* [Logical Drive Management]
→ [Delete Selected Logical
Drive]
Refer to 4.[Deleting RAID
System]
* [Logical Drive Management]
→ [Logical Drive Info and
Setting]
Refer to 3-4.[Initialization to
Created Logical Drive]
* [Logical Drive Management]
→ [Create Logical Drive]
(Step 1/2)
1) Confirm status of Disk Array
2) Selection Disk Array
(Step 2/2)
1) Setting Logical Drive Name
2) Setting RAID Level
3) Setting capacity
4) (Setting Stripe size)
5) (Setting Write Policy)
6) (Setting Read Policy)
Refer to 3-3.[Creating Logical
Drive]
No
No
No
No
No
Yes
Yes
Yes
Yes
Yes
* [Disk Array Management]
→ [Delete Selected Disk Array]
Refer to 4.[Deleting RAID
System]