Radwin TV White Space, Installation Manual

Page: 27 / 62

TV White Space Installation Guide Release 1.0 2 ‐ 19
SU Units Installation Steps
2.13.2 SU Units
Figure 2 ‐ 27: Input port: SU unit
2. Add sealant tape to the connections (see "Waterproofing" on page 2 ‐ 17. )
3. Route the CAT ‐ 5e and ground cables down from the radio to a PoE via 2 LPUs: one
near the radio, one near the PoE. Fasten CAT ‐ 5e cable connections with a cable
gland, add sealant tape.
4. Connect ground cable to ground.
5. Perform final connections via a PoE, depending on the type of PoE you are using,
as follows:
Indoor PoE
a. Connect CAT ‐ 5e cable from lower LPU to “Out” port
b. Connect LAN cable to “In” port.
c. Connect power cable
2.14 Check Connectivity to Radio
1. Connect to radio unit:
• From a laptop in the field: Disconnect the PoE from the communications network
(LAN connection), and connect the laptop.
FOR REGULATORY USES ONLY