Radwin RADWIN 2000 D+, User Manual

Page: 53 / 229

RADWIN 2000 D+ User Manual Release 3.6.00 6 ‐ 1
Chapter 6: Link Configuration
6.1 Chapter Contents
This chapter is divided into two sections covering the two phases of Link configuration:
1. Link establishment: Initial setup
2. Link maintenance: Fine tuning and special functions
Link establishment is typically a once ‐ only task. Link maintenance is required for fine ‐ tuning
the link and configuration of special features such as VLAN, Quality of Service and more.
6.2 Link Establishment
6.2.1 Link Configuration Workflow
The previous chapter showed you how to log on to the RT ‐ A(HBS).
The RT ‐ A(HBS) requires activation. The ODU will commence transmitting and receiving
packets related to link management only ‐ that is no service. Activation and Deactivation are
effected quite simply by clicking a toggle button.
Assuming that the ODU intended as Link RT ‐ B(HSU) is mounted aligned and powered up, it
will discover the Master ODU establishing a link for management only. At this point the RT ‐
B(HSU) may be managed over the air.
Having Identified the Link RT ‐ B(HSU), the latter must be registered to the RT ‐ B(HSU) to enable
traffic between them, completing phase 1.
Following registration, you can set separately,
• MIMO mode
• Transmission ratio between uplink and downlink
• Uplink and downlink Maximum Information Rate (MIR) in Mbps
• VLAN parameters
• Quality of Service parameters.
In what follows, we assume that you are logged on to RT ‐ A(HBS) on IP address as shown in the
previous chapter. Here is the opening situation: