Radwin 5000 HPMP, User Manual

Page: 89 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 5 ‐ 20
Switching Between Views
Switching Between Views

To switch between displays:
• Click the relevant tab. From left to right, the tabs are,
Map view, Table view, List view and Utilization view. The active tab (Table view in the
illustration) is shown enlarged.
Display View Persistence
The last display view used will be that opened at your next restart or log on to the RADWIN
Manager.
Which Display View Should I Use?
Your preferred view is clearly application dependent. For a geographically localized sector ‐
say, video surveillance of a plant or a sports center with a small number of cameras, Table or
List view might be adequate. Our own example is based on a backhaul situation for which the
Maps view is very helpful.
Continuing with our Example Sector
Using the Map View
To set up a new sector or to carry out substantial changes to an existing sector, you should
have a Radio Plan from your Site Survey. The minimum requirement is a list of locations and
their coordinates. Here is our plan extracted from Table 5 ‐ 2 :
Table 5 ‐ 7: Radio Plan for a small sector
Unit Type Site Name Latitude Longitude
Antenna
height (m)
fixed HSU Mozart@HFU.01.02 ‐ 37.4018 145.0086 60
fixed HSU
Haydn@HFU.01.01 ‐ 37.8762 145.0437 10
nomadic HSU Brahms@HNU.01.03 n/a n/a n/a
HBS
Bach@HBS.01 ‐ 37.8148 144.9630 130
Note
A plan of this type may be prepared by hand, or by using a suitable Radio
Planning tool. The method used here allowed us to specify antenna height
as well so as to guarantee LOS. While it is not of direct use in what follows,
antenna height is required to carry out physical installation as set out in
Chapter 4 .