Radware Alteon Installation and Maintenance Guide
Alteon Application Switch Platforms
Document ID: RDWR-ALOS-V2815_IG0203
35
Figure 11: Alteon Application Switch 5412 and 5412 XL Back Panel
Notes
>>
If the power is disconnected and reconnected (for example, after the power cord is
removed and replaced, or after a power failure), the platform returns to its previous
state. For example, if the platform was running, and then you disconnect the power
cord, when you reconnect the power cord, the platform automatically switches on.
Likewise, if the platform is not running, if you disconnect the power cord and reconnect
it, the platform stays powered off until you press the power button.
>>
For additional technical information, see
Appendix A - Specifications, page 77
LCD Module—Alteon Application Switch 5412 and 5412 XL
Alteon Application Switch 5412 and 5412 XL platforms support an LCD module, which consists of the
LCD itself and LCD menu buttons.
Note:
The Alteon 4408, 5224, 5224 XL and 10000 models do not have an LCD.
Figure 12: Alteon Application Switch 5412 and 5412 XL
The LCD displays basic information.
The LCD menu buttons are for future use.
When you turn on an Alteon Application Switch, during the boot process, the LCD displays the
following:
Table 8: Alteon Application Switch 5412 and 5412 XL Back Panel
Feature
Description
Dual power supply sockets The socket to which the power cable is connected.
CompactFlash (for future
use)
Insertion point for CompactFlash card.
Caution:
You must not remove the CompactFlash card when the
device is running.
Ground screws
Screws to ground the platform chassis to the rack. Typically, 2U units
have two ground screws.
