•
Choose
„
Counting pieces /
Minimum reference mass”
and then set an appropriate value.
Accessible settings: 1 d, 2 d, 5 d, 10 d.
Notice:
While the procedure of evaluation the mass of single piece the the mass
of all pieces put on the pan is lower than the value declared in parameter
„
Minimum reference mass”, the following warning message will
be displayed: < Too low sample mass>.
22.9. Selecting the series type
It concerns the <
Comparator> working mode
Procedure:
•
Enter group of parameters <
Working modes> according
to ch. 22 of this manual: „
Comparator /
Method”
and then choose the right method.
Accessible methods:
•
ABBA
•
ABA
22.10. Declaration of the number of measurement series
It concerns the <
Comparator> working mode
Procedure:
•
Enter group of parameters <
Working modes> according
to ch. 22 of this manual,
•
Choose:
„
Comparator /
Number of measurements”
then an editing field will appeare < Number of measurements>
with the screen keyboard,
•
Inscribe the required value and confirm it by pressing
.
73
