24.2. Setting a reference unit by entering known piece mass
Procedure:
•
Enter
mode
<
Counting Pieces>
according to ch. 24.1
of this manual,
•
Press (enter piece mass), then an editing field is displayed
<Reference Unit>
with the screen keyboard,
•
Enter a value and confirm it by pressing
, which causes starting
<
Counting Pieces>
with automatic setting the reference unit.
Notice:
1. In case of entering a reference unit higher then the maximum weighing
range of the main scale the program will display a message box:
<Value too high>,
2. In case of entering the single piece mass lesser than 0.1 e of verified
scales and 1 d for non-verified scales, the program will display a
message box: <Value to small>,
24.3. Setting a reference unit by weighing a sample
Procedure:
•
Enter
mode
<
Counting Pieces>
according to ch. 24.1
of this manual,
•
If pieces are weighed in a container it needs to be put on the pan
and tarred,
•
Press (estimate piece mass), then the editing field is displayed
<Reference Quantity>
together with the screen keyboard,
•
Enter a value and confirm it by pressing
, then the following
message is displayed:
<Put pieces: xx>
(where
xx
– the value
entered before),
•
Put the declared quantity of pieces on the pan and when the result
is stable (symbol
) confirm it by pressing
.
72
