RADWAG PUE 5.15, Service Manual

Page: 37 / 65

- 37 -
• avoid side loads, especially side shocks:
10.2. Scales zeroing
In order to zero mass readout of a presently selected platform the user has
to press
button which is to be found in a weighment display of a
„MwManager”
program (the top right hand corner) or he has to initiate
zeroing function defined for a given input (See point
9.5.3 of this manual)
.
On a display mass readout with zero value will be shown next to symbols:
and .
Zeroing means estimating a new zero point which will be recognized by scale
as an exact zero. Zeroing is possible only when display states are stable.
Caution:
Zeroing a display state is possible only within the range upto ±2% of the
maximum scales load. If zeroing value is greater than ±2% of the maximum
load then the message Err2 is displayed.
10.3. Taring
To estimate net mass for a presently selected platform the user needs to put
packaging on a device and wait for a readout to stabilize, next (s)he may
press button . The other possibility is to initiate tare function defined
for a given input (See point
9.5.3 of this manual)
.
On a display mass readout with zero value is be shown next to symbols :
Net
i . The scales has been tared.