RADWAG PS R1, User Manual, Page: 50 / 99

- 50 -
•
The total mass of all the pieces put on the weighing pan must not be greater than the balance maximum
weighing range.
•
The mass of a single piece cannot be lower than 0.1 reading unit of the balance. If this condition is not
met, the balance displays message: <Single part mass too low>.
•
While determining the number of pieces, wait for the stability pictogram , next confirm the quantity.
•
You can confirm the declared quantity by pressing button only after the stability pictogram is
displayed. Otherwise, the balance will not accept the measurement.
11.3.3. Setting the Reference Mass: Entering Mass Value
Procedure:
•
Press F button to which the function < ENTER SAMPLE > is assigned, wait to see the editing
window < ENTER SAMPLE >
•
Use arrow buttons to enter the known weight value of a single piece.
•
The balance software automatically enters < PARTS COUNTING > mode displaying the number
of pieces which are on the pan ( pcs ). In the bottom line, a single piece mass value is shown (if
the option has been selected for < INFORMATION > function)
11.4. CHECKWEIGHING
Checkweighing is a working mode that uses two thresholds (LOW and HIGH) in order to check mass
of the samples. It is generally assumed that the mass is correct if it is contained within the threshold
values.
F Shortcut Keys
You can declare which particular weighing function is to be launched using F1, F2, F3 or F4 keys.
For procedure informing you how to declare the particular function, read
F Shortcut Keys section.
11.4.1. Declaring Threshold Values
Procedure:
•
Press F button to which the function < ASSIGN THRESHOLDS > is assigned, the editing
window is displayed and the value of MIN low threshold can be ascribed. The ascribed value
must be given in a current unit.