RADWAG MAS 1. Y, User Manual

Page: 67 / 201

- 67 -
20.1. Density Determination Kit
Kit intended for XA balances:
1 Beaker base
2 Stand
3 Sinker
4 Beaker
5 Thermometer holder
6 Thermometer
7 Flexible connector for sinker
8 Hanger
9
Top weighing pan for solids
density determination
10
Flexible connector for weighing
pans
11
Bottom weighing pan for solids
density determination
12 Additional sinker
13
Additional stand for a set of pans
or a sinker
14
Additional set of weighing pans
for density determination of
solids with density lower that
density of water
CAUTION:
−
Components of density determination kit shall be stored in a box.
−
Weighing pans and sinker must not be put directly on a table, this might cause their
damage. Weighing pans and sinker, if not in use, must be put on an additional stand.
20.2. Assembly
XA balances
CAUTION:
If the kit has been installed and -NULL- message
is displayed then load the balance with weights
set (12) and zero and tare the indication. Thus
prepared balance can be used for density
determination.