RADWAG MAS 1. Y, User Manual

Page: 162 / 201

- 162 -
The video starts automatically.
Navigation buttons:
Play/ Pause playing
Stop playing
Increase/decrease the volume (volume power adjusted, for settings go to
<Misc.> menu).
Enabling/Disabling the volume
Restart video
38. COMMUNICATION PROTOCOL
GENERAL INFORMATION
A. A character based communication protocol (balance-indicator) is designed for
establishing communication between a RADWAG balance and a peripheral device via
RS-232C interface.
B. The protocol consists of commands sent from a peripheral device to the weighing
device and responses from the weighing device.
C. Responses are sent from the weighing device each time a command is received.
D. Commands, forming the communication protocol, enable obtaining data on weighing
device status and facilitate influencing weighing device operation, e.g.: acquiring
measurement results from the weighing device, zeroing, etc.
38.1. List of Commands
Command Command overview
Z Zeroing
T Taring
OT Give tare value
UT Set tare
S Send stable measurement result in basic measuring unit
SI Immediately send measurement result in basic measuring unit
SIA Immediately give results from all platforms in basic measuring units
SU Send stable measurement result in current measuring unit
SUI Immediately send measurement result in current measuring unit
C1 Switch on continuous transmission in basic measuring unit
C0 Switch off continuous transmission in basic measuring unit
CU1 Switch on continuous transmission in current measuring unit
CU0 Switch off continuous transmission in current measuring unit
DH Set min checkweighing threshold