RADWAG MAS 1. Y, User Manual

Page: 128 / 201

- 128 -
List of density reports data:
1. Sample number [field with a value, if in Density mode <YES> value is
set for <Request sample number> parameter]
2. Start date
3. End date
4. Density [calculated density of a sample, liquid or air]
5. Density [calculated volume of tested sample, density
measurement of solid body ]
6. Procedure [depending on selected procedure, data
contained on a report may change]
7. Operator [name of an operator carrying out the procedure]
8. Product [name of tested sample]
9. Standard liquid [name of a liquid used for determining density of
solid object ]
10. Standard liquid density [ density determination of solid object ]
11. Temperature [temperature of liquid used for carrying out a
measurement, density determination of solid
body]
12. Sinker volume [ density determination of a liquid ]
13.
Mass of steel standard
[ density determination of air ]
14. Mass of aluminium standard [ density determination of air ]
15. Density of steel standard [ density determination of air ]
16. Density of aluminium standard [ density determination of air ]
17. Weighing 1 [mass measurement of tested sample or a
sinker in the air, or mass of measured steel
standard
18. Weighing 2 [mass measurement of tested sample or a
sinker in liquid, or mass of measured aluminium
standard]
30.8. Control Reports
Each product control carried out using SQC or PGC mode is sent to a printer or saved to
< PGC> database. Each control saved to the database features specific number assigned
at the moment of control completion.
Control number format:
X / y y / M M / d d / H H / m m
, where:
X – control type, marked as follows:
U – control regulated by the act,
Z – control completed by an operator,
W – control regulated by an internal criteria for PGC or SQC mode
yy - year of control end,
MM - month of control end,
dd - day of control end,
HH - hour of control end,
mm - minute of control end,
You can preview data on each control.
Procedure:
•
Enter < Databases > submenu in accordance with section 30 of this user manual.