10
Manual
–
Wifi module
6.2
Manuals Update
New modules are provided with an automatic update function
at the factory. If your version does not yet support this
(firmware < 20170701), then you can start the update
manually by appending the following command. The module
must be in HTML mode for this. Please replace the IP address
in the following example with your own module address:
192.168.0.100/?updatecheck=1
The update may not yet be confirmed by a message page. After
about 1 minute you can reach the module again via its IP
address and see the new version number in the bottom right
corner, if an update was available.
6.3
Automatic update
The automatic update can be activated or deactivated in the
settings menu of the HTML mode (gear in the upper left
corner).
