11
ASSEMBLY AND OPERATION
CHECKING THE BATTERY CHARGER STATUS
The level of charge remaining in the battery can be checked by using the battery LED
power indicator that is contained on the end of the battery.
NOTE:
The battery charge remaining may be checked while the battery is installed
in the tool with the ON/OFF switch turned OFF. It may also be checked while the
battery is removed from the tool. DO NOT check the battery charge remaining while
the battery is in the charger. You will get a false reading and you may also damage
the battery status system.
1. Press and hold the battery status button located on the end of the battery.
2. One or more of the Four LED lights in the LED window will come ON to indicate the
amount of charge that is remaining in the battery as follows:
Charge level
indicator
Amount of
charge remaining
10-25%
25-50%
50-75%
75-100%
3. Release the battery status button to turn the LEDs OFF.
CHARGING THE BATTERY PACK
1. Place the battery charger (1) in a dry location near a 120V 60 Hz electrical outlet (Fig. 1).
2. Plug the battery charger into the outlet and make sure the green LED indicator light
(5) comes ON. If it does not, refer to the chart (Fig. 2) to identify the problem.
3. Turn the battery (2) upside down and slide it onto the charger.
NOTE:
Make sure the
grooves (3) in the sides of the battery slide over the matching tabs on the charger (4)
until the battery latch “clicks” into place.
3. Turn the battery (2) upside down and slide it onto the charger.
NOTE:
Make sure the grooves (3) in the sides of the battery slide over the
matching tabs on the charger (4) until the battery latch “clicks” into place.