RadiSys P3000BX2 Series, Service Manual

Page: 32 / 64

6 Steps to Operation
24 EPC-2322 SBC (P3000(D)BX2 Series) Service Manual
Main The options for the Main menu are continued in the following table:
Advanced
The options for the Advanced menu are listed in the following table:
Option / Sub-Menu Item Default Setting Alternate Settings
»
Boot Options Summary Screen Enabled Disabled
Floppy Check Disabled Enabled
Quiet Boot Screen Disabled Enabled
POST Errors Enabled Disabled
»
Keyboard Features Numlock Auto On, Off
Key Click Disabled Enabled
Keyboard Auto-Repeat Rate 30/sec 26.7/sec, 21.8/sec, 18.5/sec,
13.3/sec, 10/sec, 6/sec, 2/sec
Keyboard Auto-Repeat Delay 1/2 sec 1/4 sec, 3/4 sec, 1 sec
Extended Memory N/A Display only N/A
Memory Bank 0 N/A Display only N/A
Memory Bank 1 N/A Display only N/A
Option / Sub-Menu Item Default Setting Alternate Settings
»
I/O Device Configuration /
Integrated Peripherals Serial Port A Enabled (user configures) Disabled (no configuration),
Auto (BIOS / OS configures)
Note: Base I/O Address and Interrupt are available only if the
Serial Port is Enabled.
Note: For console redirection, select Enabled.
Serial Port A: Base I/O
Address 3F8 2F8, 3E8, 2E8
Serial Port A: Interrupt IRQ 4 IRQ 3
Serial Port B Enabled Disabled, Auto
Note: Base I/O Address and Interrupt are available only if the
Serial Port is Enabled.
Note: For console redirection, select Enabled.
Serial Port B: Base I/O
Address 2F8 3F8, 3E8, 2E8
Serial Port B: Interrupt IRQ 3 IRQ 4
Parallel Port Enabled Disabled, Auto
Note: Mode, Base I/O Address, and Interrupt are available
only if the Parallel Port is Enabled.
Parallel Port: Mode Bi-Directional Output Only (ISA), EPP, ECP
Note: If Mode is set to ECP, you must set the DMA.
Parallel Port: Base I/O
Address 378 278, 3BC
Parallel Port: Interrupt IRQ 7 IRQ 5
Parallel Port: DMA Channel DMA 3 DMA 1
Note: This option is available only if Mode is set to ECP.
Floppy Disk Controller Enabled Disabled
Floppy Disk Controller:
Base I/O Address Primary Secondary
Local Bus IDE Adapter Enabled Disabled
Adaptec Ultra-2 SCSI Adapter Disabled Enabled
Note: The SCSI controller uses PCI IRQ line 1 (INTA).
StockCheck.com