RadiSys EPS-6315, Hardware Reference Manual, Page: 42 / 123

EPC
®
-6315 Hardware Reference
32
Reset Configuration Data Determines whether to clear the Extended System
Configuration Data (ESCD) block that resides in the Flash
Boot Device (FBD).
You can select one of these:
•
No (default) : Does not clear the ESCD block.
• Yes : Clears the ESCD block. You must clear the block
the first time a system is turned on or if the ESCD
becomes corrupted. This option automatically resets to
“No” after the block is cleared.
PCI Configuration
sub-menu Displays a menu that you use to configure PCI devices.
For more information, see
PCI Configuration
sub-menu on page 33.
Cache Memory sub-menu Displays a menu that you use to control the use of the
CPU cache. For more information, see Cache Memory
sub-menu on page 38.
Console Redirection
sub-menu Displays a menu that you use to redirect console output.
For more information, see
Console Redirection
sub-menu on page 43.
I/O Device Configuration
sub-menu Displays a menu that you use to configure peripheral
devices. For more information, see
I/O Device
Configuration sub-menu on page 45.
Large Disk Access Mode Specifies whether MS-DOS systems can use hard disks up
to 8GB (1024C x 255H x 63S) without special drivers
or LBA.
If the drive fails while installing new software, change this
setting and try again.
You can select one of these:
•
DOS (default) : Causes the System BIOS to perform
cylinder/head translation if the drive is configured in
Setup to have more than 1024 cylinders. Select this
option if your system uses a drive larger than 528 MB
and runs DOS or MS-DOS
†
.
• Other : Select this option if your system uses a drive
larger than 528 MB and runs an OS other than DOS.
Local Bus IDE Adapter Configures the integrated local bus IDE adapter.
You can select one of these:
• Enabled (default)
• Disabled
Field Description