1997 Radionics All rights reserved
The Radionics logo is a registered trademark of Radionics,
1800 Abbott Street, Salinas, CA 93901, USA
34377B 04/97
D9024/D10024
Networking Guide
Page 13 of 18
D10024
SHIFT
G
T
6
[Active] 1)Commission 2)Test 3)Time [1]
4)Enable 5)Disable 6)PRINT 7)View
O
A
N
0
B
C
P
1
2
D
Q
E
R
3
4
F
S
5
H
U
7
V
I
J
W
8
9
K
X
L
Y
M
Z
CHANGE
Figure 32: Main Menu
Select option one 1) Commission, by pressing the “1” key.
The display prompts, “Please key in your password”
[Active] 1)Commission 2)Test 3)Time [1]
4) Enable 5)Disable 6)Print 7)View
1)CONFIGURE YES)More Options [A]
2)INSPECT 3)NORMAL OPERATION
1)Time/Date 2)Program Integrity [A]
3)Power Supplies 4)Modify level 2 code
1)Day Modes 2)Setup options 3)Network [A]
Press the "1" Key
Press the "YES" Key
Press the "YES" Key
Press the "3" Key
Enter Pass Code
Figure 33: Path Through Commission Menus to Network
Enter the Level Three Pass Code
(9898)
.
The display shows the first of the three Commission Menus.
Press
YES
twice to page to Commission Menu Three.
Press 3 to enter Network options.
Unlock the memory using the Memory Lock Switch. The memory must be locked at the end of
the programming session. The panel will not allow a reset unless the memory is locked.
Press 3. The panel displays Network Menu One.
Panel network - address number = ?
Figure 34: Network Menu One
Enter the Network address for the Master Panel. This is a number from one to 20.
Note: In messages on the LCD, the panel software will identify the first sl
ave panel as
Slave CPU 1
,
the second slave panel as
Slave CPU 2
, and so on.
Avoid confusion between network addresses and panel identifications by giving the master panel
a unique identification number (i.e. 10).
The panel displays Network Menu Two.
Quantity of slave processors = ?
Figure 35: Network Menu Two
Enter the number of slave processors (1 to 9 in a report and control network). The panel
displays Network Menu Three
