RadioLink Electronic Ltd
24
Push SWB/SWC switch to the lower position (DOWN will be displayed in the upper right corner of the screen),
the method is the same as above;
2. If you set SWA or SWD switch. Press it to one dual rate value, and release it to another dual rate value.
3. LK-A, LK-B, LK-C, LK-D are corresponding to the lock mode of SWA, SWB, SWC, SWD switches. Press it
to one dual rate value, and press it again to another dual rate value.
2.15 Brake Side Adjustment "ATL"
Brake side adjustment
This function decreases the set value when the braking effect is strong and
increases the set value when the braking effect is weak.
Setup Item
RATE: Brake amount
Brake amount (RATE)
0%~100%
Initial value: 100%
(1) Enter the function menu and use “Dec(-)” or “Inc(+)”button to access ATL
function.
(2) Press “Enter” button to get into ATL function interface.
(3) Press “Enter” key, and the initial value of RATE will blink. Use “Dec(-)”or“Inc(+)” button to adjust the value.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing “Dec(-)” and “Inc(+)”
buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
(4) When ending setting, return to the initial screen by pressing“Exit” button twice.
2.16 Programmable Mixes "PMIX01/02"
Programmable mixes between arbitrary channels
These functions allow you to apply mixing between the steering, throttle, CH3, CH4, CH5, CH6 and CH7.
PMIX01 setting is the same with PMIX02.
Programmable Mixes "PMIX"
MXMD:Mix mode
Enter the function menu and use“Dec(-)”or “Inc(+)” button to access PMIX
function, then press “Enter” button to get into PMIX function interface.
MOD: Mixing mode.
INH: means the mixing function is disabled. Regardless of whether there is
a set control switch or value under this function, it is not enabled.
ON/OFF: means turning the function on and off. Set the mode to ON, the
current mixing control can take effect.
SW: Switch to control the mix function. You can set SWA, SWB, SWC,
SWD, or the lock modes of these four switch buttons LK-A, LK-B, LK-C,
LK-D. "NULL" means no switch assigned. After setting the travel amount of the corresponding channel, the
transmitter will always execute the set value by default.
POS: means the position of the switch used to control this function. UP (up)/DOWN (down)/CNT (central): It
indicates the position of the selected switch. Push/Press the switch to different positions to set different travel
amount.
LEFT: Mixing rate (Left side)
