3) Working current: 38-45mA（input voltage: 5V）
4) Size: 43*24*15 MM
5) Receiver integrate telemetry sensor including signal strength and voltage. Support extended
engine voltage telemetry module PRM-01 and module PRM-02 can feedback GPS info, Speed,
voltage etc. on AT9/AT9S/AT10 display when work with flight controller APM or PIX.
6) 4096 section precision, 0.25us per section, servo anti-shake rudder.
7) MINI receiver, just need one cable if use SBUS signal.
Installment of receiver antenna：
1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
2. Large model aircraft may of some metal part interfering signal; in this case the antennas
should be placed at both sides of the model. Then the best RF signal condition is obtained at any
flying attitude.
3. The antennas must be kept away from conductive materials, such as metal and carbon by at
least a half inch. The coaxial part of the antennas does not need to follow these guidelines, but do
not bend it in a small radius.
4. Keep the antennas away from the motor, ESC, and other noise sources as much as possible.
5. Press and hold the Easy Link (ID SET) one second, now the receiver starts work.
6. After all of the above steps finished, the LED indicator will turn and keep in red.
7. The receiver can be packed by sponge or foam for shocking proof when it is installed to the
model.
After all of the above steps finished, turn off the transmitter and then power it on, now the
program functions to assure it under control of transmitter with a right connection
