RadioLink Electronic Ltd
11
10.
Note of Antenna Installation
In order to maximize the signal transmission, it’s greatly advised that
1. Keep antennas as straight as possible, or the effective control range will reduce.
2. Keep the two antenna in 90° angle as shown below
3. Big models may contain metal parts that influence signal emission. In this case. antennas should be
positioned at both sides of the model to ensure the best signal status in all circumstances.
4. Antennas should be kept away from metal conductor and carbon fiber at least half inch away and no
over bending.
5. Keep antennas away from motor, ESC or other possible interference sources.
6. Sponge or foam material is advised to use to prevent vibration when installing receiver.
7. Receiver contains some electronic components of high-precision. Be careful to avoid strong vibration
and high temperature.
8. Special vibration-proof material for R/C like foam or rubber cloth is used to pack to protect receiver.
Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which would possibly make
the receiver out of control.
Thank you again for choosing RadioLink product.
