RadioLink Electronic Limited
9
AT9S Pro/AT9S/AT9/AT10/AT10II
①
Enter BASIC MENU, select MODEL TYPE and choose MULTIROTOR.
②
Back to BASIC MENU, select REVERSE and set CH3 Throttle as REV.
③
Back to BASIC MENU, select AUX-CH and set CH7 control switch as SwA.
④
Enter ADVANCE MENU, select ATTITUDE and set the CHANNEL as CH5, SW3 as SWC with up position as
AltHold Mode, middle position as Stabilize Mode and low position as Manual Mode.
* For more setting instructions of different RadioLink transmitters, please visit
to download the
corresponding detailed e-manual.
3.6 Binding
There’s no need to bind because the binding is complete with receiver R8SM installed by factory default if the
RTF version (whole pack including T8S+F121+bag) you have purchased.
However, if you want to change the control transmitter, binding between the transmitter and receiver needs to
done first.
If fly F121 Pro with RadioLink transmitter and receiver, binding steps are same as following.
①
Place the transmitter and receiver(installed on F121 Pro) close to each other within 50 centimeters.
