56
3.1.15 ATTITUDE
Attitude is set to switch different flight modes.There are 28
models in total. The function needs to work with flight controller.
After the transmitter connects with flight controller, name the
model in the transmitter to match with the flight mode in the
flight controller.
Channel: The attitude channel of ACRO defaults to channel 5.
It can be set from channel 5-channel 10.
There are 6 different attitude modes for MULTIROTOR:
NORMAL, ATTI, GPS, HOVER, F/S and AUX. Every mode will
have a different rate to get a unique signal. NORMAL mode
preset 0%, ATTI 50%, GPS 100%, HOVER 25%, F/S 75% and
AUX 50%.
0% means a output signal 1ms, and 100% means 2ms. You
can totally get 6 different modes by adjusting the related rates.
Goals
Steps
Inputs
Set the
ATTITUDE of
MULTIROTO
R.
In ADVANCE menu find the
ATTITUDE function.
urn on the transmitter,
for 1 sec. to BASIC
menu (If ADVANCE,
again)
to ATTITUDE
Assign the switch to control
attitude. Ex: SW3 is SWC
，
SW2 is
SWB
to
SW3
,
，
to SWC
，
to
SW2
,
，
to SWB
，
Set the rate in each attitude.
Ex: ATTI is 60%.
to
rate-ATTI
,
，
to 60%
，
Close
3.1.16 SERVO-DLY
The SERVO-DELAY function is used to slow the response of the servo to stimulate the slow response of a
turbine engine. This function may also be used to create a “slowed servo” on every channel.
Adjustment range: 0%~100%
Goals
Steps
Inputs
Slow down the
response of rudder
and elevon
Open SERVO-DLY
to BASIC .
again to ADVANCE
to SERVO-DLY,
Adjust the RATE to match the
desired servo speed.(Ex:40%)
to RATE.PUSH
to 40%
Close
3.2 GLID ADVANCE MENU
