46
using AILE-DIFF.
Note that the function
defaults to no difference in
down travel vs. up travel. If
you want differential travel,
simply adjust each side.
(Ex: 90%)
to AILE-DIFF .PUSH.
Activate the function.
to MIX
，
PUSH.
to ACT
Optional: adjust the
up/down travel for 2
servos..(Ex:90% down)
to AILE1
AILERON STICK.
to 90%
to AILE2,
AILERON STICK
，
to 90%
Close
* If you receive an error message that OTHER WING MIXING IS ON, you must deactivate ELEVON or
FLAPERON.
3.1.5 Air Break (ACRO/ GLID)
ACRO
GLID
Like FLAPERON and AILEVATOR, AIRBRAKE is one function that is really made up of a series of
pre-programmed mixes all done for you within the radio. AIRBRAKE (often called "crow" or BUTTERFLY -
see GLID, p. 62 for details) simultaneously moves the flap (if installed), twin ailerons (if installed) and elevator,
and is usually used to make steep descents or to limit increases in airspeed in dives.
This function is often used even on models without flaps as an easy way to use the FLAPERON and
FLAP-ELEVATOR mixing together.
Adjustability:
• Activation: be proportional by moving the THROTTLE STICK, or set positions by flipping the assigned
switch.
• Switch: Mix SWITCH is selectable.
• Also LOGIC SW (Lsw1 to 3) may be assigned.
• Linear(Inversely proportional to THROTTLE STICK): Provides a proportional increase in amount of
AIRBRAKE action as THROTTLE STICK is lowered and assigned switch is on. It provides gradually more
AIRBRAKE as you slow the engine. Includes selectable stick position where AIRBRAKE begins, gradually
increasing to the same setting as the THROTTLE STICK is lowered. If you would like to have the airbrake be
directly proportional to throttle stick, you will
need to reverse the THR-REV function. Note that this changes the throttle stick direction for all models.
• Offset: Provide AIRBRAKE response immediately upon switch movement, going to a pre-set travel on each
active channel without any means of in-flight adjustment.
• During Airbrake operation, the elevator travel is displayed on the elevator trim display in the Startup screen.
•Delayed reaction: You can suppress sudden changes in your model's attitude when
AIRBRAKE BUTTERFLY is activated by setting the delay (delay-ELEV) item, to slow down the elevator
