13
signal and original CH2 to CH6 output CH6 to CH10 PWM signal at the same time.
1.3.3 The connection of the receiver
Dupont thread is used to connect the receiver. The common color is white/red/black or yellow/red/brown.
The signal wire is light color, while the ground wire is dark color. The three wires are corresponding
to
. When connecting with the servo wires, the signal wire is upward and the ground wire is
downward.
Note: All RadioLink receivers are designed with Anti-polarity connect protection. When the connection of
the servo wires are reversed, the receiver will stop working and it won’t be damaged. But when connecting
the servo at this time, the servo may be damaged.
The below chart is to introduce the default output channel of the receiver when setting different models.
Take acrobatic as an example.
RX
output
& CH
Glider
ACROBASI
C
Helicopter
Car/Boat
GLID
（
1A+1 F
）
GLID
(2A+1F)
GLID
(2A+2F)
ELEV
ON
FLAPERO
N
AILE-DIFF AILE-DIF
F
1
Combi
ned
elev-2
&ailero
n1
elev-1
&ailero
n-2
Combined
flap-2
&aileron-1
aileron-1
Aileron-1
ailerons/aile
ron-1¹/com
bined
flap-2&ailer
on-1¹
aileron/cycli
c roll
Spare/rudde
r
2
Combi
ned
elev-1
&ailero
n-2
Elevator/co
mbined
rudder-2&e
lev-1¹
Elevator/c
ombined
rudder-2&
elev-1¹
Elevator/
combined
rudder-2
&elev-1¹
e
levator
Elevator/cycl
ic pitch
Spare/throttl
e
